RM Solar S Class 20 Manual de Instruções descarregar pdf (Página 47)

47 48

Joining Exhibition A Frames Together

When you have constructed both frames you will connect them together by inserting the frame

connector (FIX0302) into the Z-Rail. The frame connector will be inserted approximately 180mm

into the Z-Rail at the top and bottom of the frame. There are no pre-drilled holes in these Z-Rails

to insert the bolts so you will require a 6.5mm H.S.S. bit to afx them. (Two bolts for each Z-Rail).

Take the next frame and slide the Z-Rails onto the frame connectors that are protruding from the

rst frame, drill and bolt. The frames will now be joined.

Exhibition A Frame alts. to Accomodate Econ Panels

At the base of the A-Frame uprights are two holes (A)

These will be the

new holes (B)

Bolt Into (A)

on A Frame

(A)

Take the extensions and bolt it onto the frame using holes (A). Then with a 6.5mm H.S.S. drill bit

drill the two holes beneath the original holes (A).

The new holes drilled (B) will now hold the bottom horizontal bar in the correct position.

Gable Mounting Instructions

The A-Frames can be mounted to either a strong wall or gable end. Once the frames have been

constructed drill adequate holes in the back support rails and raw bolt the frame on to the gable

end/wall. If there is any doubt whether the wall/gable can support the weight of the solar array

please consult a structural engineer. We cannot be responsible for errors made in not taking

expert advice, as different walls and structures have different load bearing capabilities.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 67 68

Sem comentários

RM Solar S Class 20 Manual de Instruções Página 47